Of course, if you only use a USB sound card, the following settings are not required.įirst, install the USB sound card and check if it is recognized. For example, when HDMI is connected, the onboard chip of Raspberry Pi has priority, and there is a symptom that it is not output from the USB sound card. The cause is when there is audio output other than the USB sound card. If there is no sound after installing the WAVESHARE USB sound card, you need to set it. Once these are ready, the Mini vMac will be ready for acceptance. * The reason is that my approach may not be good, but I tried rc.local, Systemd, and cron, but it didn’t work, and in conclusion, I wrote it in “.bashrc”. $ sudo apt-get install xserver-xorgĮnable “Console Autologin” in the familiar “raspi-config”. Install the minimum Xwindow related required to boot a Mini vMac over the CLI. (Personal opinion)Īfter inserting the Micro SD card into the Raspberry Pi and booting, let’s upgrade the OS first. Since various settings are troublesome with CLI, to shortcut the work. * At that time, set the network and SSH with “Ctrl + Shit + X”. Use Raspberry Pi Imager for installation. The settings do not need to be done on a small screen. * The GPIO display will be installed and set at the end. Step 1: Environmental Preparation for Raspberry Pi OS Lite
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |